Introduction
RBFS allows you to set the timer information for ARP and ND routes. The timer information specifies how frequently a device sends messages to its neighbor. RBFS provides a logical interface with which you can configure timers for neighbor router. These timers are essential for protocol such as ARP and ND.
RBFS supports timers for the following attributes:
- Gratuitous ARP Interval
-
The Gratuitous ARP is sent as a broadcast by a node to communicate its IP address to MAC address mapping on the network. The GARP timer enables you to specify the interval time based on which GARP can be communicated.
- Neighbor Probe Interval
-
RBFS allows you to configure the neighbor probe interval for the specified interface. This attribute is used to ensure that the neighbor is available or not.
- Router Advertisement Interval
-
RBFS allows you to configure router advertisement interval. Router advertisement includes route information to show the network hosts that the router is operational. The router sends these messages periodically with a time range specified with minimum and maximum values. Router Advertisement Interval timer is applicable only to IPv6.
- Neighbor Scan Interval
-
It specifies the time interval for neighbor router scanning. It scans the ARP table of a neighbor router to determine which IP addresses are active.
- ARP Throttle Interval
-
ARP throttling is a method of rate limiting of ARP packets and it safeguards the router by limiting too many ARP requests triggered by incoming traffic. RBFS allows you to configure the time interval for ARP throttling.